I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
Very pleased with the quality of the scan. No complaints whatsoever.
Text excerpt from page 265 (click to view)
ink supply station SVC - step 3 To remove Ink supply station SVC: 1. The holder raceway is located below the top cover of the printer. Remove the holder raceway belt from its slot in the ink supply station. 2. Unscrew the two T10 screws located on the cover on top of the Ink Supply Station. 3. Remove the top cover of the Ink Supply Station. 4. Remove the T10 screw from the base of the Ink Supply Station. 5. Pull out the two harnesses that secure the ink supply station to the motor and the carriage belt. 6. Remove the holder raceway. 7. Use a pair of tweezers to remove the clip of the ink supply harness. Free all harnesses that are secured to the ink supply station. 8. Remove the ink supply station.
ISS rear foam SVC - C8109-67023
First remove the following: 1. Assy. Tray Main SVC 2. Second tray with base SVC 3. Assy. Output Tray SVC 4. Assy. Door Access SVC 5. Printhead Door Assy. SVC 6. Filter Assy. 7. Tube holder SVC 8. Back cover 9. Cover front SVC 10. Right Cover Assy. SVC 11. Ink Supply Station SVC
ISS rear foam SVC To remove ISS rear foam SVC: 1. The ink supply station foam is located at the rear of the ink supply station. After removing the Ink supply station, remove the ISS Rear Foam.
ISS bottom foam SVC - C8109-67022
First remove the following: 1. Assy. Tray Main SVC 2. Second tray with base SVC Service and Repair hp restricted 5 - 51
